- AutorIn
- Udo Sobe
- Karl-Heinz Rooch
- Dietmar Mörtl
- Titel
- Simulation and Analysis of Analog Circuit and PCM (Process Control Monitor) Test Structures in Circuit Design
- Zitierfähige Url:
- https://nbn-resolving.org/urn:nbn:de:swb:ch1-200700919
- Quellenangabe
- Dresdner Arbeitstagung Schaltungs- und Systementwurf - Band 5
- Abstract (EN)
- PCM test structures are commonly used to check the produced wafers from the standpoint of the technologist. In general these structures are managed inside the FAB and are focused on standard device properties. Hence their development and analysis is not driven by analog circuit blocks, which are sensitive or often used. Especially for DFM/Y of analog circuits the correlation between design and technology has to be defined. The knowledge of electrical behavior of test structures helps to improve the designer's sensitivity to technological questions. This paper presents a method to bring the PCM methodology into the analog circuit design to improve design performance, yield estimation and technology correlation. We show how both analog circuit and PCM blocks can be simulated and analyzed in the design phase.
- Freie Schlagwörter
- Analog circuit design
- Process Control Monitor (PCM) methodology
- Statistical Process Control
- Wafer fabrication (FAB)
- Klassifikation (DDC)
- 004
- 500
- Normschlagwörter (GND)
- Mikrosystemtechnik
- Schaltungsentwurf
- HerausgeberIn
- Prof. Dr. Wolfram Hardt
- Publizierende Institution
- Technische Universität Chemnitz, Chemnitz
- URN Qucosa
- urn:nbn:de:swb:ch1-200700919
- Veröffentlichungsdatum Qucosa
- 08.06.2007
- Dokumenttyp
- Konferenzbeitrag
- Sprache des Dokumentes
- Englisch